Change-Pole Multi-Speed/YD series Motor
YD series motors by changing the winding connection, can obtain different output and speed to drive equipment with high efficiency.
Specification
| Frame size | H80-280mm |
| Rated power | 0.45kW-82kW |
| Voltage and frequency | 380V/50Hz |
| Installation Method | B3/B5/B35/V1 |
| Degrees of protections | IP55/IP56/IP65/IP66 |
| Degrees of insulation/Temperature rise | F/B |
| Installation Method | B3/B5/B35/V1 |
| Ambient temperature | -15C ~+40°C |
| Relative humidity should beless than 90% | |
| Altitude should be lower than 1000 m above sea level. | |
| Cooling MethodDimensions YD and IE1 series are the same | IC411、IC416、IC418、IC410 |
Ordering Information
● This catalogue is only a reference for users. Please forgive that if any change ofproducts will not make additional specify in advance.This catalogue is only a reference for users. Please forgive that if any change ofproducts will not make additional specify in advance.
● Please note the rated data when ordering, such as the motor type,power,voltage, speed, insulation class, protection class, mounting type and so on.
● We can design and produce special motors as followed according to therequirement of customer:
1. special voltage, frequency and power;
2. special insulation class and protection class;
3. with terminal box on the left side, double shaft ends and special shaft;
4. high temperature motor or low temperature motor;
5. used on plateau or outdoor;
6. higher power or special service factor;
7. with heater, PT100 for bearings or winding, PTC and so on;
8. with encoder, insulated bearings, or insulated bearing structure;
9. with others requirement.
